Find your dealer here
If you do not have a local dealer,
We can sell direct by check or bank transfer,
and we can provide shipping quotations to anywhere in the world.
(N-19 options: ALL BLACK or with BLUE PROP SHROUD)
All lead acid scooters are supplied with a standard 4 amp charger, weight is ony 2 pounds.
OPTIONAL CHARGER for Genesis Lead Acid : Interacter 8 Amp
Weight 12 pounds
Additional $75 or $175 if purchased separately.
Maximum times to 95% charge:
UV-18 100 minutes
UV-26 180 minutes
UV-42 5 hours
COLOR OPTIONS, NO EXTRA CHARGE.
ALL
BLACK
BLUE
SHROUD, BLACK NOSE AND TAIL
BLACK
SHROUD, BLUE NOSE/TAIL 
BLUE
SHROUD, BLUE NOSE/TAILRecommended accessory for N-19 and UV-N-37:
Mityvac (tm) vacuum pump ($65) can be used to test integrity of NiMH sealed battery packs.
We have manufactured the N-19 and UV-N-37 battery packs with a separate, sealed compartment.
This tool allows this compartment to be leak tested, via the vent screw. This tool can also be used to
test the motor compartment and rear shaft seal on any Submerge scooter (UV or N-19) in addition to
the motor compartment on a Gavin scooter, and the battery compartment on a Tekna scooter
(via the charging port)
Instructions: it will take about 30 hand pumps to pull a 10 inch vacuum. The guage should stay steady
if tested for a few minutes, or overnight. If there is a leak, be sure to check your connections to the Mityvac pump.
Burntester:
Scooter burntesters consist of a large resistor which simulates the approximate load of
the scooter motor, in this case 24 volts and 16 amps. This is the best way to check the condition
of your batteries.
Submerge Burntesters include a battery over-discharge protection circuit (LVC), which switches off the
tester at the correct time.. when the batteries voltage drops to 21 volts.
BURNTESTER INSTRUCTIONS CLICK HERE
This tester is designed to test 24 volt batteries only.
This includes: Any UV battery pack (2x 12 volt lead acid, 24 volt pack)
N-19 and UV-N-37 packs
Home