Submerge UV-26 battery pack assembly

Parts: 2 x Genesis 26a/h batteries
Bulkhead assembly, ring spacer,
4 x 6mm S/S bolts, wiring harness.
Tools required:
1 x 7/16th wrench, 1 x 7/16 wrench or 
adjustable
1 x 10mm socket driver







This is the alignment of the batteries 
to the bulkhead.









Step 1:
remove nuts and washers from top bulkhead














2: 
slide middle bulkhead up about 1/2"















3:
Slide battery in, making sure not to
damage wires.

NOTE position of battery to slot in
the lower spacer.









4:Replace top bolts loose















5:Slide in battery















6: Install spacer.
If it is tight, loosen threaded rod from
the bottom.











7: tighten top nuts,
being carefull not to over tighten.















8: This is correct













9: this is over tightened, note
the top bulkhead is bowed.














10:attach positive leads, with the 
thicker power lead contacting the 
battery terminal











11: Do not over tighten,
a socket driver is all you need
not a wrench.











12: attach negative leads,
with the thicker power lead contacting 
the battery terminal.











13: Now connect the junper cable,
positive to negavive between the 2 
batteries











Finished!
It should look like this.

Return tohomepage